V90=<Rate>-Enable/Disable V.90 Settings - US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Command Reference Manual

Result codes:
-V90=<rate>—Enable/Disable V.90 Settings
Result codes:
Command
-V90=<rate>
-V90=0
-V90=1
-V90?
-V90=?
OK if <value> = 0, 1.
ERROR if <value> does not equal 0, 1.
-C<value> Commands
Table 3-46:
Command
-C0
-C1
OK if <rate> = 0—23.
ERROR if <rate> does not equal 0—23.
Table 3-47: -V90 Commands
Controls the downstream rate. See Table 3-48: -V90=<rate> Equivalent Down-
stream Rates for the possible values of <rate>.
Disables V.90.
Enables V.90 auto rate (default).
Displays the current value.
Shows the range of <rate>.
Function
Disabled (default).
Enabled.
Function
56K Softmodem
Command Reference
- 32