Machining Small Contour Steps: M - HEIDENHAIN ITNC 530 User Manual

Machining small contour steps: M97

Standard behavior
The TNC inserts a transition arc at outside corners. If the contour steps
are very small, however, the tool would damage the contour.
In such cases the TNC interrupts program run and generates the error
message "Tool radius too large."
Behavior with M97
The TNC calculates the intersection of the contour elements—as at
inside corners—and moves the tool over this point.
Program M97 in the same block as the outside corner.
Instead of M97 you should use the much more powerful
function M120 LA (see "Calculating the radius-
compensated path in advance (LOOK AHEAD): M120" on
page 272)!
HEIDENHAIN iTNC 530
Y
Y
S
13
14
X
S
16
17
15
X
267