Hr 420 Electronic Handwheel - HEIDENHAIN ITNC 530 User Manual

HR 420 Electronic Handwheel

Unlike the HR 410, the HR 420 portable handwheel is equipped with
a display. In addition, you can run important setup functions through
the handwheel soft keys, e.g. setting datums or entering and running
M functions.
As soon as you press the handwheel activation key, it activates the
handwheel and deactivates the control panel. This is indicated by a
pop-up window on the TNC screen.
The HR 420 handwheel features the following operating elements:
1 EMERGENCY OFF button
2 Handwheel display for status display and function selection
3 Soft keys
4 Axis address keys
5 Handwheel activation key
6 Arrow keys for definition of handwheel sensitivity
7 Direction key by which the TNC moves the selected axis
8 Switch on the spindle (machine-specific M function)
9 Switch off the spindle (machine-specific M function)
10 NC-block creation key
11 NC start
12 NC stop
13 Permissive button
14 Handwheel
15 Spindle speed potentiometer
16 Feed rate potentiometer
If M118 is active, it is even possible to move the machine axes with the
handwheel during the program run.
Your machine manufacturer can make additional
functions of the HR 420 available. Please refer to your
machine manual.
58
2
6
5
7
8
9
10
15
2 Manual Operation and Setup
1
3
4
6
7
11
12
13
14
16