HEIDENHAIN ITNC 530 User Manual page 356

Machining operation (0/1/2) Q215: Define the
machining operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing
Side finishing and floor finishing are only executed if
the finishing allowances (Q368, Q369) have been
defined.
1st side length Q218 (incremental value): Pocket
length, parallel to the reference axis of the working
plane.
2nd side length Q219 (incremental value): Pocket
length, parallel to the minor axis of the working plane.
Corner radius Q220: Radius of the pocket corner: If
you make no entry here, the TNC assumes that the
corner radius is equal to the tool radius.
Finishing allowance for side Q368 (incremental
value): Finishing allowance in the working plane.
Angle of rotation Q224 (absolute): Angle by which
the entire pocket is rotated. The center of rotation is
the position at which the tool is located when the
cycle is called.
Pocket position Q367: Position of the pocket in
reference to the position of the tool when the cycle is
called:
0: Tool position = Center of pocket
1: Tool position = Lower left corner
2: Tool position = Lower right corner
3: Tool position = Upper right corner
4: Tool position = Upper left corner
Feed rate for milling Q207: Traversing speed of the
tool in mm/min while milling.
Climb or up-cut Q351: Type of milling operation with
M03.
+1 = climb milling
–1 = up-cut milling
356 8 Programming: Cycles