HEIDENHAIN ITNC 530 User Manual page 647

TNC displays, TNC editor
Cycles 17, 18 and 207:
Oriented spindle stop
at beginning of cycle
Programming station
Acknowledgment of
POWER INTERRUPTED
after switch-on
ISO programming: Set
the block number
increment
Disabling the selection
of file types
Disabling the editor for
certain file types
Note:
If a particular file type is
inhibited, the TNC will
erase all files of this type.
Configure pallet files
Configure datum files
Program length for
program check
Program length up to
which FK blocks are
permitted
HEIDENHAIN iTNC 530
MP7160
Oriented spindle stop: 0
No oriented spindle stop: 1
MP7210
TNC with machine: 0
TNC as programming station with active PLC: 1
TNC as programming station with inactive PLC: 2
MP7212
Acknowledge with key: 0
Acknowledge automatically: 1
MP7220
0 to 150
MP7224.0
All file types selectable via soft key: +0
Disable selection of HEIDENHAIN programs (soft key SHOW .H): +1
Disable selection of ISO programs (soft key SHOW .I): +2
Disable selection of tool tables (soft key SHOW .T): +4
Disable selection of datum tables (soft key SHOW .D): +8
Disable selection of pallet tables (soft key SHOW .P): +16
Disable selection of text files (soft key SHOW .A):+32
Disable selection of point tables (soft key SHOW .PNT): +64
MP7224.1
Do not disable editor: +0
Disable editor for
HEIDENHAIN programs: +1
ISO programs: +2
Tool tables: +4
Datum tables: +8
Pallet tables: +16
Text files: +32
Point tables: +64
MP7226.0
Pallet table inactive: 0
Number of pallets per pallet table: 1 to 255
MP7226.1
Datum table inactive: 0
Number of datums per datum table: 1 to 255
MP7229.0
Blocks 100 to 9999
MP7229.1
Blocks 100 to 9999
647