HEIDENHAIN ITNC 530 User Manual page 650

TNC displays, TNC editor
Configure tool table
(To omit from the
table: enter 0); Column
number in the tool
table for
650
MP7266.16
Cutting direction – DIRECT.: 0 to 32; column width: 7 characters
MP7266.17
PLC status – PLC: 0 to 32; column width: 9 characters
MP7266.18
Offset of the tool in the tool axis in addition to MP6530 – TT:L-OFFS: 0 to 32
column width: 11 characters
MP7266.19
Offset of the tool between stylus center and tool center – TT:R-OFFS: 0 to 32
column width: 11 characters
MP7266.20
Tolerance for break detection in tool length – LBREAK: 0 to 32; column width: 6 characters
MP7266.21
Tolerance for break detection in tool radius – RBREAK: 0 to 32; column width: 6 characters
MP7266.22
Tooth length (Cycle 22) – LCUTS: 0 to 32; column width: 11 characters
MP7266.23
Maximum plunge angle (Cycle 22) – ANGLE.: 0 to 32; column width: 7 characters
MP7266.24
Tool type –TYP: 0 to 32; column width: 5 characters
MP7266.25
Tool material – TMAT: 0 to 32; column width: 16 characters
MP7266.26
Cutting data table – CDT: 0 to 32; column width: 16 characters
MP7266.27
PLC value – PLC-VAL: 0 to 32; column width: 11 characters
MP7266.28
Center misalignment in reference axis – CAL-OFF1: 0 to 32; column width: 11 characters
MP7266.29
Center misalignment in minor axis – CAL-OFF2: 0 to 32; column width: 11 characters
MP7266.30
Spindle angle for calibration – CALL-ANG: 0 to 32; column width: 11 characters
MP7266.31
Tool type for the pocket table–PTYP: 0 to 32; column width: 2 characters
MP7266.32
Limitation of spindle speed – NMAX: – to 999999; Column width: 6 characters
MP7266.33
Retraction at NC stop – LIFTOFF: Y / N; column width is 1 character
MP7266.34
Machine-dependent function – P1: –99999.9999 to +99999.9999; column width: 10 characters
MP7266.35
Machine-dependent function – P2: –99999.9999 to +99999.9999; column width: 10 characters
MP7266.36
Machine-dependent function – P3: –99999.9999 to +99999.9999; column width: 10 characters
MP7266.37
Tool-specific kinematics description – KINEMATIC: Name of the kinematics description;
column width: 16 characters
MP7266.38
Point angle – T_ANGLE: 0 to 180; column width: 9 characters
MP7266.39
Thread pitch PITCH: 0 to 99999.9999; column width: 10 characters
14 Tables and Overviews