HEIDENHAIN ITNC 530 User Manual page 622

Setting Meaning
OPTIONS for Data without spaces, separated by commas,
FILESYSTEMTYPE and written in sequence. Switch between
=nfs upper and lower case letters.
RSIZE=: Packet size in bytes for data
reception. Input range: 512 to 8192
WSIZE=: Packet size in bytes for data
transmission. Input range: 512 to 8192
TIME0=: Time in tenths of a second, after
which the TNC repeats a Remote Procedure
Call. Input range: 0 to 100 000. If there is no
entry, the standard value 7 is used. Use
higher values only if the TNC must
communicate with the server through
several routers. Ask your network specialist
for the proper value.
SOFT=: Definition of whether the TNC should
repeat the Remote Procedure Call until the
NFS server answers.
"soft" entered: Do not repeat the Remote
Procedure Call.
"soft" not entered: Always repeat the
Remote Procedure Call.
OPTIONS for Data without spaces, separated by commas,
FILESYSTEMTYPE and written in sequence. Switch between
=smb for direct upper and lower case letters.
connection to IP=: IP address of PC to which the TNC is to
Windows be connected
networks USERNAME=: User name under which the TNC
is to log on
WORKGROUP=: Work group under which the
TNC is to log on
PASSWORD=: Password with which the TNC is
to log on (up to 80 characters)
AM Definition of whether the TNC upon switch-
on should automatically connect with the
network drive.
0: Do not automatically connect
1: Connect automatically
The entries USERNAME, WORKGROUP and PASSWORD in the
OPTIONS column may not be necessary in Windows 95
and Windows 98 networks.
With the ENCODE PASSWORD soft key, you can encode
the password defined under OPTIONS.
Defining a network identification
Press the soft key DEFINE UID / GID to enter the network
identification.
622 13 MOD Functions