Lpu-Nsq1Xp20 - 3Com H3C SECPATH F5000-A5 ADVANCED VPN FIREWALL 12-PORT GIGABIT ETHERNET MODULE Installation Manual

LED
GE0 through
GE11
(yellow/green)
SFP8 through
SFP11
(yellow/green)
LPU–NSQ1XP20
Introduction
An NSQ1XP20 provides two Ten-gigabit small form-factor pluggable (XFP) interfaces, delivering
high-speed service process capabilities. The front panel of the LPU provides one LED for each interface.
Currently, this LPU supports only the LAN PHY mode, but not the WAN PHY mode. Note that:
NSQ1XP20 can be inserted in slot 1, 2, 3, or 4 of the F5000-A5.
The F5000-A5 needs to be equipped with an MPU and at least one LPU to work normally.
Figure 1-6 Front view of NSQ1XP20
(1) Captive screw
(3) XFP interface 0
(5) XFP interface 1
(7) LPU LED (RUN)
Technical specifications
Table 1-8 Technical specifications of NSQ1XP20
Memory type and size
XFP interfaces
Power consumption monitoring
Status
OFF
Solid green
Blinking green
Solid yellow
Blinking yellow
OFF
Solid green
Blinking green
Solid yellow
Item
No link is present on the corresponding interface.
A 1000 Mbps link is present on the interface.
Data is being transmitted or received at 1000 Mbps.
A 10/100 Mbps link is present on the interface.
Data is being transmitted or received at 10/100 Mbps.
No fiber link is present on the interface.
A fiber link is present on the interface.
Data is being transmitted or received at 1000 Mbps.
The optical module fails to be detected.
(2) Eject lever
(4) XFP interface 0 LED (XFP0)
(6) XFP interface 1 LED (XFP1)
DDR2 SDRAM
1 memory slot
512 MB (default), 1 GB (maximum)
2
10GBASE-R
Supported
1-9
Description
Description