3Com H3C SECPATH F5000-A5 ADVANCED VPN FIREWALL 12-PORT GIGABIT ETHERNET MODULE Installation Manual page 14

Technical specifications
Table 1-6 Technical specifications of NSQ1GT8C40
Item
Memory type and size
Electrical interfaces
Combo interfaces
Power consumption monitoring
A Combo interface is comprised of an electrical interface and a small form-factor pluggable (SFP)
interface.
For an optical/electrical Combo interface, the default operating interface is the electrical interface.
For a Combo interface, either the electrical interface or the optical interface can operate at one time.
You can use the combo enable { copper | fiber } command in interface view to switch between the
electrical and optical interfaces. For details about the combo enable { copper | fiber } command,
refer to H3C SecPath Series Security Products User Manual.
LEDs
Table 1-7 Description of the LEDs on NSQ1GT8C40
LED
OFF
Slow blinking (1 Hz)
RUN
Fast blinking (8 Hz)
(green)
Reset
DDR2 SDRAM
1 memory slot
512 MB (default), 1 GB (maximum)
8
10 Mbps, half/full duplex
100 Mbps, half/full duplex
1000 Mbps, full duplex
4 (electrical/optical)
Electrical interfaces
Optical interfaces
Supported
Status
No power input or the LPU is faulty.
The LPU is operating normally.
The application software is being loaded (in this state,
never power off the device or hot-swap the LPU; otherwise
the LPU may be damaged), or the LPU is not working.
The RUN LED goes off after the system is reset and
flashes fast on system startup.
1-8
Description
10 Mbps, half/full duplex
100 Mbps, half/full duplex
1000 Mbps, full duplex
1000 Mbps, full duplex
Description