Installing And Removing An Mpu; Structure Of An Mpu; Installing An Mpu - 3Com H3C SECPATH F5000-A5 ADVANCED VPN FIREWALL 12-PORT GIGABIT ETHERNET MODULE Installation Manual

Installing and Removing an MPU

Structure of an MPU

Figure 7-2 Interior structure of the MPU
(1) Guide pin
(3) CPU heatsink
(5) Built-in CF card
(7) Bus connector
(9) RESET button
(11) Run LED (RUN)
(13) Alarm LED (ALM)
(15) USB interface 1 (1)
(17) USB interface 0 (0)
(19) AUX port (AUX)
(21) HA port link state LED (LINK)
(23) HA port (HA) (10/100/1000BASE-T)
(25) Data reception & transmission LED of the
management Ethernet port (ACT)
(27) Ejector lever

Installing an MPU

Step1 Face the front panel of the firewall.
Step2 Remove the blank panel of slot 0 from the position. For how to remove a blank panel, refer to "Installing
and Removing a Blank Panel" on page 7-9.
Step3 Gently and steadily push the MPU into the slot along the slide rails, and then push the ejector levers
inward to lock the board in position.
(2) Left release latch
(4) Memory module and slot
(6) Right release latch
(8) Power connector
(10) External CF card LED (CF)
(12) MPU active/standby state LED (ACT)
(14) USB 1 state LED (USB1)
(16) External CF card slot
(18) CF card eject button
(20) Console port (CONSOLE)
(22) Data reception & transmission LED of the
HA port (ACT)
(24) Ethernet link state of the management
Ethernet port (LINK)
(26) Management Ethernet port
(MANAGEMENT) (10/100/1000BASE-T)
(28) Captive screw
7-3