Table of Contents
Advertisement
Step1 Face the front panel of the firewall.
Step2 Locate the power module to be removed, and loosen the captive screws on the power module by
turning them counterclockwise with a Philips screwdriver.
Figure 7-21 Loosen the captive screws
Step3 Gently pull the power module out along the slide rails.
Figure 7-22 Pull out the power module
To protect the removed power module, place it in an antistatic bag.
If you do not install a new power module in the slot, install a blank panel to prevent dust from
entering the chassis. For how to install a blank panel, refer to "Installing and Removing a Blank
Panel" on page 7-9.
7-14
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the H3C SECPATH F5000-A5 ADVANCED VPN FIREWALL 12-PORT GIGABIT ETHERNET MODULE and is the answer not in the manual?
Questions and answers