Installing A Blank Panel - 3Com H3C SECPATH F5000-A5 ADVANCED VPN FIREWALL 12-PORT GIGABIT ETHERNET MODULE Installation Manual

Step1 Face the front panel of the firewall.
Step2 Locate the blank panel to be removed, loosen the two captive screws by turning them counterclockwise
with a Philips screwdriver. Then, remove the blank panel.
Figure 7-15 Remove a blank panel from an LPU slot
Place the removed blank panels and screws in a safe place for later use.
It is recommended to install blank panels in all the empty slots to ensure the normal ventilation in
the firewall.

Installing a Blank Panel

After an LPU is removed from the firewall, it is recommended to install a blank panel if you do not install
a new LPU in the slot.
To install a blank panel, reverse the removal procedure.
Step1 Face the front panel of the firewall.
Step2 Locate the slot where you will install a blank panel, cover the blank panel on the slot, and then fasten the
captive screws by turning them clockwise with a Philips screwdriver.
Figure 7-16 Install a blank panel in an LPU slot
7-11