Table of Contents
Advertisement
Figure 7-3 Insert the MPU into the slot
Step4 Fasten the captive screws by turning them clockwise with a Philips screwdriver.
Figure 7-4 Fasten the captive screws
Step5 Turn on the power switch of the firewall if the firewall is powered off.
Step6 After the MPU is powered on, the RUN LED (green) flashes fast (8 Hz). It flashes slowly (1 Hz) after the
MPU application is loaded. This means that the MPU runs normally.
The MPU of the firewall is not hot-swappable.
For more information about the MPU LED, refer to Chapter 1 "Firewall Overview."
Removing an MPU
To remove an MPU, reverse the installation procedure.
Step1 Face the front panel of the firewall.
Step2 Loosen the captive screws by turning them counterclockwise with a Philips screwdriver.
7-4
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the H3C SECPATH F5000-A5 ADVANCED VPN FIREWALL 12-PORT GIGABIT ETHERNET MODULE and is the answer not in the manual?
Questions and answers