Cable-Tie Bar - Removing And Replacing - IBM 4851 514 Planning, Installation And Service Manual

Updated October, 2008
Figure 48. Removing the rear metal panel cover
2. Locate the rear metal panel cover ( A in Figure 48).
3. Loosen the two captive screws shown as B in Figure 48 and carefully slide the
Cable-tie bar – removing and replacing
1. Remove the rear cover as shown at "Rear cover – removing and replacing" on
cover from the top hinges to remove.
page 61.
Removing and replacing FRUs
Chapter 5. Removing and replacing FRUs
63