Hinge Assembly - Removing And Replacing - IBM 4851 514 Planning, Installation And Service Manual

Updated October, 2008
Figure 61. Removing HDD cover clips
Hinge assembly – removing and replacing
1. Remove the tablet. See "Display tablet – removing and replacing" on page 55.
2. Remove the HDD front cover. See "HDD cover – removing and replacing" on
3. Remove the top cover. See "Top cover – removing and replacing" on page 70.
4. Remove the center cover. See "Tower center cover – removing and replacing"
5. Remove the four screws shown in Figure 62 on page 76.
Reverse the steps to replace.
page 73.
on page 71.
Removing and replacing FRUs
Chapter 5. Removing and replacing FRUs
75