Install An Optional Serial Port Fan Out Cable - IBM XStation 130 Set Up And Operation Manual

Step 12. Install an Optional Serial Port Fan Out Cable
The Xstation provides access to two serial ports from one 25 pin D-shell connector. The
first serial port is accessible by direct attachment to the 25 pin D-shell connector (5) on the
I/O panel of the Xstation.
Access to the second serial port requires the installation of the optional Serial Port Fan Out
cable.
Do you want to install an optional Serial Port Fan Out cable?
No Go to "Step 13. Install an Optional Tablet" on page 1-20.
Yes
Perform the following steps:
1. If installed, remove the device attached to the 25 pin D-shell connector (S) from the I/O
panel.
2. Attach the Serial Port Fan Out cable to the 25 pin D-shell connector (S).
3. If removed, reconnect the device to the Serial Port Fan Out cable connector marked "S1".
4. If desired, connect a second device to the connector marked "52".
I/O Panel
I
'----ll
c==l
J.----'
I
~V
0 01
<
~
/
~
V ET
~
s
P
M
d
Ie>
c=>o<
> <
>0 I
I
Serial Port
Fan Out Cable
5. Go to "Step 13. Install an Optional Tablet" on page 1-20.
Setup
1-19