Installing The Msr - IBM 4851 514 Planning, Installation And Service Manual

Installing the IBM SurePOS 500 Model 514
Figure 5. Memory module removal and insertion
5. Replace the rear inner metal cover.
6. Replace the rear cover (see "Rear cover – removing and replacing" on page

Installing the MSR

Two types of MSRs can attach to the SurePOS 500 Series display:
Note: The installation of either MSR is identical.
v Dual-sided, single-track MSR (RS-232 interface only)
v Three-track MSR (RS-232 or keyboard interface)
Note: Before installing the three-track MSR, set the slide switch D in Figure 6 on
1. Switch Off the power at the system unit.
2. Holding the MSR parallel to the side of the display, place the front edge of the
3. Install the screw provided with the MSR, as shown in Figure 6 on page 9. Use
8
SurePOS 500 Model 514
61).
page 9 that is located on the MSR to the correct setting for either RS-232 or
keyboard interface. See Figure 6 on page 9.
MSR so that the recesses on the MSR fit onto the plastic tabs on the rear
cover. Slide the MSR down to latch it into position. Be careful that you do not
pinch the cable.
care not to overtighten the screw.
Updated October, 2008
Retainer