IBM 4851 514 Planning, Installation And Service Manual page 46

Mounting the SurePOS 500 Model 514
Figure 23. Attaching mounting plate to the cash drawer integration tray
30
SurePOS 500 Model 514
b. Attach the SurePOS 500 Series base mounting plate A to the right side
of the integration tray. Slide the front of the plate under the appropriate pair
of tabs on the integration tray. Secure the rear of the plate to the tray with
two thumbscrews as shown in Figure 23.
c. Attach the printer base mounting plate C to the integration tray. Slide the
front of the plate under the appropriate pair of tabs on the integration tray.
Secure the rear of the plate to the tray with two thumbscrews.
d. Attach the printer B to the printer base mounting plate by sliding it onto
the two tabs until it locks in place.
5. Plug the cash-drawer cable into the cash drawer and route it under the
cable-tie bar to the rear connector panel.
6. Plug the data and power cables into the printer, routing the data cable toward
the rear connector panel.
7. Route all cables through the hole at the center rear of the cash drawer. Then
route the cables through the rear of the system, laying them flat on top of the
cash-drawer integration tray.
Updated October, 2008
B
C
A