Table of Contents
Advertisement
Installing additional peripheral devices
Installing additional peripheral devices
Attention: Before you use the following procedures to install additional peripheral
devices, see Appendix D, "Safety information," on page 123.
Mounting a distributed customer display and APA display to a cash
drawer
The SurePOS 500 Series provides a powered, 15-pin, serial port for attaching a
distributed customer display, APA character-graphic display, or other device
requiring a powered serial connection. The SurePOS 500 Series distributed
customer display is mounted behind the cash-drawer modesty panel. It can also be
mounted to a countertop with customer-provided hardware. Use these instructions
to mount a character display to a cash drawer.
1. Prepare the system for installation of the distributed customer display.
2. Prepare the distributed customer display to be installed on an integration tray.
Figure 33. Attaching the distributed customer display cable
3. Go to the appropriate procedure for a non-keyboard integration tray or keyboard
42
SurePOS 500 Model 514
a. Switch OFF the power at the system unit.
b. Remove the SurePOS 500 Series rear cover (see "Rear cover – removing
and replacing" on page 61) to access the rear connector panel.
a. Route the distributed customer display cable through the mounting post (and
post extension, if used) and plug the cable into the display, as shown in
Figure 33.
b. Attach the character display top to its post by pressing the display down on
the post until it snaps into place.
integration tray to complete the installation of the distributed customer display:
v For installation of a distributed customer display on a non-keyboard
integration tray, go to Step 4 on page 43.
v For installation of a distributed customer display on a keyboard integration
tray, go to Step 5 on page 44.
Updated October, 2008
Hide quick links:
Advertisement
Table of Contents
