Rear Tower Components; Rear Cover - Removing And Replacing; Rear Cover Removal - IBM 4851 514 Planning, Installation And Service Manual

Updated October, 2008

Rear tower components

This section describes how to remove and replace components that are viewed and
accessed from the rear of the tower.
Rear cover – removing and replacing
1. Facing the rear of the system, press in on both sides A , and lift upward B ,
2. Lift outward to remove.
To replace, reverse the removal procedure.
Figure 46. Rear cover removal
as shown in Figure 47 on page 62 and Figure 46, rotating the bottom of the
cover toward the back C .
Removing and replacing FRUs
Chapter 5. Removing and replacing FRUs
61