Installing The Keyboard-Integration Tray On A Cash Drawer - IBM 4851 514 Planning, Installation And Service Manual

Mounting the SurePOS 500 Model 514
Figure 27. Installing the keyboard-integration tray on a cash drawer
36
SurePOS 500 Model 514
2) If you are routing cables on top of the counter, route them out the back
of the system. Lay them flat along the countertop.
5. Remove the rear cover on the cash drawer. While pressing in on the two
buttons located on the sides of the cash drawer, pull back on the rear cover
back to remove it. Discard this rear cover. A new rear cover is used for
installation of the keyboard integration kit.
6. Install the keyboard-integration tray on a cash drawer:
D
A
a. Tilt the integration tray down so the three tabs B align with the three tab
holes C on the cash drawer as shown in Figure 27. Set the integration
tray down on the cash drawer while aligning the screw holes D with holes
on the cash drawer.
b. Secure the integration tray to the cash drawer with two screws at location
D .
7. Place the plastic insulator plate E on the integration tray while aligning the
cutout and the four screw holes.
8. Attach the mounting plate F to the integration tray with four plastic washers
and screws as shown in Figure 27.
9. Attach the fence G to the integration tray with six small screws.
G
F
E
C
Updated October, 2008
B