IBM 4851 514 Planning, Installation And Service Manual page 45

Updated October, 2008
Figure 22. Attaching a mounting plate to center of cash-drawer integration tray
2. To install the SurePOS 500 Model 514 on an integration tray:
a. Remove the rear cover.
b. Remove the base plate. See "Base plate - removal and replacement" on
page 77.
c. Attach the system base to the mounting plate B with the screws C , as
shown in Figure 22.
d. Open the rear cash drawer cover D by pushing in the two buttons located
on each side of the cash drawer. This provides access to the cash drawer
connector for cabling it to the system. You will also route cables inside the
cover through hole E and to the system.
C
3. For installations without a printer, install the mounting plate in the center of
the base using the removable thumbscrews. Place the filler panels on both
sides. See Figure 19 on page 26. Install printer panel G first and use filler
panels K to lock in filler panel G onto the tray.
4. Install the IBM 4610 SureMark printer on the integration tray with the SurePOS
500 Model 514. Go to "Installing IBM 4610 SureMark Models TF6 or TF7
printers" on page 44 for detailed instructions on printer cable routing, RS-232
printer switch settings, and mounting plate installation:
a. Plug the data and power cables into the printer, routing the data cable
toward the rear connector panel as shown in Figure 37 on page 46.
Mounting the SurePOS 500 Model 514
B
E
D
Chapter 3. Mounting the SurePOS 500 Model 514
29