Removing and replacing FRUs
Figure 41. Removing the tablet back cover
2. With the tablet face down on a sturdy surface, loosen the three screws along
3. If installed, remove the antenna cover.
4. Using both hands, lift the base rear upward and tilt it at an angle to remove.
Display tablet cable – removing and replacing
1. Remove the tablet. See "Display tablet – removing and replacing" on page 55.
2. Disconnect the cable from the bottom rear of the tablet.
3. Remove the HDD front cover as described at "HDD cover – removing and
4. Disconnect the cable clamps holding the tablet cable.
5. Remove the rear cover as described at "Rear cover – removing and replacing"
6. Remove the power supply as described at "Power supply – removing and
7. Disconnect the connector from the system board.
8. Remove the base plate. See "Base plate - removal and replacement" on page
9. Pull the cable free from the plastic guide in the frame.
56
SurePOS 500 Model 514
the bottom edge of the tablet. See B in Figure 41.
replacing" on page 73.
on page 61.
replacing" on page 68.
77.
Updated October, 2008