Removing And Replacing The Latch And Sensor Assembly; Removing And Replacing Components Of The Latch And Sensor Assembly - IBM 4851 514 Planning, Installation And Service Manual

Updated October, 2008
3. Reinstall the lock retainer clip.
4. Reinstall the drawer.

Removing and replacing the latch and sensor assembly

To remove the latch and sensor assembly:
1. Disconnect the cash-drawer cable from the connector at the rear of the cash
2. Remove the cash drawer (see "Removing and replacing a full-size drawer" on
3. Reach in from the front and push the latch on each side of the latch assembly
4. Slide the assembly out of the base.
Figure 70. Cash-drawer latch and sensor assembly
To replace the latch and sensor assembly:
1. Slide the assembly into the base from the front and align it with the slots in the
2. Make sure that the latching mechanism is unlatched.
3. Reinstall the drawer.
4. Reconnect the cash-drawer cable.
Removing and replacing components of the latch and sensor
assembly
To remove the individual components of the latch and sensor assembly:
1. Disconnect the cash-drawer cable.
2. Remove the cash drawer (see "Removing and replacing a full-size drawer" on
3. Remove the latch and sensor assembly (see "Removing and replacing the latch
drawer.
page 79).
inward while pulling the assembly toward the front (see Figure 67 on page 81).
Spring Retainer
Cash Drawer
Propulsion Spring
base. Push the assembly to the rear until it locks into place.
page 79).
and sensor assembly").
Removing and replacing FRUs
Pawl Latches
Latch Plate Bracket
Cam Latches
Pawl
Cam Spring
Cam
Chapter 5. Removing and replacing FRUs
Screws
Card Assembly
83