Spectra Logic Spectra 12K Install Manual page 26

Attach the Rails
You will be installing the front and back halves of the rails first, then you will connect
the two halves to make one solid rail for each side. To determine the front and back of
the rails, see Figure 37 and Figure 38 below.
Note:
If you know the exact dimensions of your rack, use the chart on
page 5, and attach your rails accordingly. Then attach the rails to
the desired height, and go to Mount the Library in the Rack on
page 29. Otherwise, use the following procedure to install the
rails.
Figure 37 The front rail.
Figure 38 The back rail.
Note:
The two front rails are identical to each other, as are the two back
rails. It does not matter which rail you use for the right or left side.
1. Use the #2 Phillips screwdriver to attach the back of the right rail to the rack with
three 10-32 x 1/2-inch screws (Figure 39).
Rack Mount Installation Guide
26