Advertisement
5
Quick start
Before installing and using the product, accept the evaluation product license agreement from the
epla
webpage.
Follow the sequence below to configure the STM32MP257F-EV1 Evaluation board and launch the demonstration
application (refer to
To start using this board, follow the steps below:
•
To identify correctly all device interfaces from the host PC, install the Evaluation USB driver available on
the
www.st.com
•
Check that jumper JP4 is in the right position ([2-3]: power from 5V/3A jack wall charger on CN20, [1-2]:
5 V/3 A USB Type-C
•
To power the board, connect the Evaluation board to a 5 V/3 A USB Type-C
the USB connector (CN21) or to the computer with USB Type-C
POWER (LD6) green LEDs light up, and the COM LED (LD5) blinks.
•
The software demonstration and several software examples, which allow the user to use the Evaluation
features, are available at the
•
Develop an application using the available examples.
UM3359 - Rev 2
Figure 4
and
Figure 5
for component location).
website, before connecting the board.
®
charger on CN21) and JP3 is OFF on the board.
www.st.com/stm32mp2
®
charger with its cable through
®
. As a result, the 5V_PWR (LD11) and
webpage.
UM3359
Quick start
www.st.com/
page 6/56
Advertisement
Need help?
Do you have a question about the STM32MP257F-EV1 and is the answer not in the manual?
Questions and answers