Pulling The Drive Sled Out Of The Library (Drive Sled Without Esd Springs Shown) - Dell PowerVault TL2000 User Manual

2
SAS cable
3
SCSI terminator
4
Fibre Channel cable
5
Ethernet cable
6
Power cords
7
Drive sled blue captive thumbscrews
8
Black pull-out tab
9
Drive sled
10
Drive sled handle
Figure 10-6. Pulling the drive sled out of the library (drive sled without ESD springs shown)
4. If present, remove the conductive tape from the drive sled (refer to Figure 10-8
on page 10-7).
5. Loosen the blue captive thumbscrews ( 7 in Figure 10-5 on page 10-4) on the
drive sled.
6. Pull straight back on the drive handle sled ( 10 ) to remove it from the library
(see Figure 10-6).
7. Before installing the new drive sled, inspect all connectors on the drive sled.
Ensure that the connectors are intact, free of any foreign objects, and have no
cracks, deformed or bent contacts.
8. Extend the black pull-out tab ( 8 in Figure 10-5 on page 10-4) located
underneath the library near the lower right corner of the drive sled.
9. Slowly insert the new drive sled into the drive slot, and align the connectors
on the library while supporting the bottom of the drive sled (see Figure 10-7
on page 10-6). Ensure that the black tab remains extended ( 8 in Figure 10-5
on page 10-4).
Chapter 10. Check, Adjust, Remove, and Replace
10-5