Removing The Front Bezel; Pulling The Shelf Chassis Out - Dell DD9500 Manual

Removing the front bezel

About this task
NOTE: You must remove the front bezel to gain access to the internal components. Remove it only to replace or add an
internal component.
Steps
1. If the bezel has a lock, insert the key that shipped with your shelf into the lock, and turn the key to unlock the bezel.
2. Press the two latch buttons on the bezel surface to release the bezel from the cabinet.
3. Pull the bezel off the cabinet and put it on a clean, static-free surface.
Figure 76. Removing the front bezel

Pulling the shelf chassis out

NOTE: Do not extend more than one shelf at a time. Extending more than one shelf at a time can cause the rack to tip
over, which will damage the equipment and may injure personnel.
About this task
To access the internal components, you must release and pull the shelf out of the cabinet. The shelf slides out of the cabinet far
enough for you to access its internal components and then locks on the rails in the service position so that you cannot pull it out
any farther. The chassis is freed from the cabinet by removing captive shoulder screws which attach the chassis to the cabinet.
Steps
1. Unscrew the attaching screws from the NEMA channel.
2. Unscrew the shoulder-screws until they are free from the cabinet. Using the orange shelf latch handles, pull the slowly pull
shelf completely out the cabinet.
90 Add Storage Capacity
CL4667