Configure: Set Access Pin Menu; Configure: Restore Defaults Menu - Dell PowerVault TL2000 User Manual

v DHCP - (Dynamic Host Configuration Protocol) If this is enabled, your library
v IP Address - the IP address of the library
v Netmask - the Network Mask address of the library
v Gateway - the Gateway address of the library
v Ethernet - the current speed setting of the ethernet interface
Configure: Set Access PIN
Use this menu item to enable/disable, set or change the Access PIN (personal
identification number) which is used to restrict access to the Control, Configure,
and Service menus.
The Operator Control Panel (OCP) pin is turned off by default, but it is strongly
recommended to be enabled if your environment requires unit security. Enabling
the OCP pin feature prevents the unit settings from being tampered with. Users
will be allowed to review the library status and manipulate media without
entering the OCP pin.
If a unit administrator needs to make a configuration change in the unit, the OCP
will ask for the 4-digit code in order to allow access to make changes. Once all the
changes are completed the pin access will expire after 5 minutes of inactivity in the
OCP (there is no log-out function in the library for this feature). A library reboot is
recommended after making configuration changes to the library.
Figure 5-16. Configure: Set Access PIN menu
Configure: Restore Defaults
Use this menu item to restore the factory default settings.
When reducing the number of drives in your library, factory default settings must
be restored to remove the Attention LED on the front panel and the exclamation
mark on the Home screen indicating that a drive is missing.
Figure 5-17. Configure: Restore Defaults menu
Important: Restoring factory defaults will wipe out all the previous configuration
data. The user must restore factory defaults when library drive configurations are
5-24
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
– Web Interface (IPv6 Only and Dual Stack): Monitor Library → Library
Identity
host will negotiate the connection with the library. If DHCP is disabled, the
following information is necessary to establish the remote access.
Configure
Set Access PIN
Configure
Restore Default