Service: Service Menu - Dell PowerVault TL2000 User Manual

Figure 5-22. Service: Service menu
The following drive diagnostics and service procedures are available in this menu:
v Clean Drive - The accessor takes the cleaning cartridge from the dedicated
v Drive Tests - Power On Self Test (POST), Normal Read/Write Test, Head Test,
v Drive Power - use this item to turn drive power ON and OFF
5-28
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
Drive Tests
Clean Drive
cleaning cartridge slot (DCS), or previously reserved slot if no DCS is available,
and inserts it into the drive. After the cleaning is complete, the accessor removes
the cleaning cartridge from the drive and returns it to the dedicated cleaning
cartridge slot or reserved slot.
Media Test
1. Navigate to the desired test (Service → Service → Drive Tests). Choose the
drive if more than one is installed.
2. Follow the instructions, and, if required, insert a blank or scratch cartridge
into the I/O Station when requested.
3. The test will execute.
– If the test PASSES, resume normal library operations.
– If the test FAILS, an error will be displayed. Make note of the error, then
refer to "Isolating Drive Sled Problems" on page 7-10.
4. Remove the cartridge from the I/O Station, if needed, then close the I/O
Station.
5. Press Cancel to exit the screen.
Note: When configuration changes of a disabled drive are made from the
Operator Control Panel (OCP), the drive powers ON after committing
changes. When configuration changes of a disabled drive are made from
the Web Interface (RMU), the drive does not power ON after committing
changes.
Service
Service
Drive Power