Unpacking The Library; Verifying The Shipment; Removing The Plastic Protective Sheets From The Library; Location Criteria - Dell PowerVault TL2000 User Manual

Table 4-1. Location criteria (continued)
Criteria Definition
Clearance
v Back: Minimum of 15.4 cm (6 inches)
v Front: Minimum of 30.8 cm (12 inches)
v Sides: Minimum of 5.08 cm (2 inches)
Rack requirements Standard 19-inch rack with:
v 2U (63.5 mm/3.5 in.) of clearance for a 2U library
v 4U (177.8 mm/7 in.) of clearance for a 4U library
Rackmounting the library is optional.

Unpacking the Library

Note: If the temperature in the room where the library will be installed varies by
1. Before you begin, clear a work surface to unpack the library.
2. Open the shipping container and carefully remove the shipping materials from
3. Lift the library out of the carton and remove the bag from the library. Remove
4. Remove all clear plastic protective sheets from the library.
Figure 4-1. Removing the plastic protective sheets from the library

Verifying the Shipment

Verify that the following items are included in your library shipment:
v With every library:
4-2
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
15° C (30° F) from the room where the library was stored, allow the library
to acclimate to the surrounding environment for at least 12 hours before
unpacking it from the shipping container.
the top of the library. Remove the accessory package and set it aside.
Important: Once the drive is unpacked, save and store the packaging materials
for future moves or shipping.
the foam cushion from the back of the library. Save the packaging materials for
future use.
Important: Do not place the library on the front panel or the rear panel as this
may damage the library. The display should NOT be touched
during the removal of the unit from the packaging.
– Power cord
– Cleaning cartridge