Error Codes - Dell PowerVault TL2000 User Manual

Table 8-1. Error Codes (continued)
Error Code Description
50 SCSI: cartridge belongs to another
partition
54 SCSI: failure in LME interface
55 SCSI: invalid license key entered
58 Recovered Error: SCSI parity error
59 Recovered Error: Error log overflow
60 Cleaning tape installed
61 Cleaning failure Cleaning process could
not be performed
62 Cleaning tape expired
63 Invalid cartridge Drive has rejected the
data tape as invalid
64 Invalid cleaning cartridge Drive has
rejected the cleaning tape as invalid
65 Invalid upgrade cartridge Drive has
rejected the upgrade tape as invalid
70 Currently not used
71 Currently not used
72 Currently not used
73 SCSI: overlapped command attempt
74 SCSI: echo buffer overwritten
80 Bar code reader Error, cannot initialize
BCR
81 Bar code reader Error, no response from
BCR
82 EEPROM (Electrically Erasable
Programmable Read-Only Memory )
Error, no response from EEPROM
(located on accessor controller)
83 Accessor controller generic problem
84 Setting of gripper motor parameters
failed
85 Setting of slider motor parameters failed
86 Setting of elevator motor parameters
failed
87 Setting of rotation motor parameters
failed
88 Setting of sled motor parameters failed
User Action
Check application software.
Command successful after retries.
Complete the cleaning process and retry the operation.
Check cleaning tape and exchange if necessary. Retry
operation
Exchange cleaning tape
Check cartridge regarding tape and drive technology and
retry operation. After further occurrence exchange data
cartridge.
Check cleaning cartridge and retry operation. After further
occurrence exchange cleaning tape.
Retry operation, after further occurrence contact technical
support for new upgrade tape
Check the application software.
Contact technical support.
8-3
Chapter 8. Error Codes