The Configure Library: Drive Screen; Choosing Drive(S) Interface Identification/Settings - Dell PowerVault TL2000 User Manual

8. Click Activate to apply the changes.
9. Install the Dell Encryption Key Manager (EKM) application on your host. Refer

Choosing Drive(s) Interface Identification/Settings

1. Click Drives in the left navigation pane.
Figure 4-26. The Configure Library: Drive screen
2. Select the desired settings for each drive listed (either SCSI, SAS, or Fibre
3. Click one of the following:
backup and recovery. These settings are required for Library Managed
Encryption only. Enter the EKM Server Setting information.
v Primary IP address (IPv4 or IPv6): Enter the IP address of the primary EKM
server.
v Primary TCP port: After entering the Primary IP address, the library will
automatically set the value of the Primary TCP port.
v Secondary IP address (IPv4 or IPv6): Enter the IP address of the secondary
EKM server.
v Secondary TCP port: After entering the Secondary IP address, the library
will automatically set the value of the Secondary TCP port.
Note: The Default Port for TCP (SSL disabled) is 3801. The Default Port for
SSL is 443. These values are the default values set by the library. They
can be changed depending on the user configuration but the user has
to make sure they match the EKM properties file.
Note: If SSL is enabled the encryption host configuration will request a SSL
port instead of a TCP port. Review your Dell PowerVault Encryption
Key Manager User's Guide for instructions to locate the appropriate port
settings.
to the Dell EKM documentation provided with your Encryption packet. The
EKM IP address and EKM port will be provided to the user by the EKM
application.
Channel). See Figure 4-26.
v Refresh - to update the current screen
v Submit - to apply the changes made to the screen
Chapter 4. Installation and Configuration
4-23