Using Factory Defaults As Your Configuration; Configuring Your Library Using The Web User Interface - Dell PowerVault TL2000 User Manual
Tape library
Hide thumbs
Also See for PowerVault TL2000:
- User manual (283 pages) ,
- Reference manual (116 pages) ,
- Configuration manual (22 pages)
Table of Contents
Advertisement
Using Factory Defaults as Your Configuration
The table below shows the main default library settings. If you wish to use the
defaults, no other changes need to be made before using your library
Item
Logical Libraries
Active Slots
I/O Slots
DHCP
Internet Protocol
Bar Code Label Length
Library Mode
AutoClean
Encryption
For a full list of factory defaults, see "Configure: Restore Defaults" on page 5-24.
Configuring Your Library using the Web User Interface
To configure your library using the Web User Interface, complete the following
procedures:
1. "Entering Network Settings using the Operator Control Panel"
2. "Logging on to the Web User Interface" on page 4-17
3. "Verifying/Updating Firmware" on page 4-17
4. "Choosing General Library Settings" on page 4-18
6. "Entering Path Failover Feature Activation Key" on page 4-21
7. "Setting Up Encryption" on page 4-21
8. "Choosing Drive(s) Interface Identification/Settings" on page 4-23
9. "Entering Library Network Settings" on page 4-24
10. "Entering User Access Information using the Web User Interface" on page
4-26
11. "Entering Date and Time using the Web User Interface" on page 4-26
page 4-27
4-28
4-28
16. "Logging out of the Web User Interface" on page 2-7
Entering Network Settings using the Operator Control Panel
Static library network settings must be entered using the Operator Control Panel
before the library can be accessed remotely using the Web User Interface. If your
Default Setting
1
Maximum
Enabled
Enabled
IPv4 Only
8
Random
Disabled
Application Managed Encryption (AME)
Chapter 4. Installation and Configuration
4-15
Advertisement
Chapters
Table of Contents
Troubleshooting
