Remove Hard Drive Carrier From The Mid Hard Drive Tray - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Hide thumbs Also See for EMC Integrated Data Protection Appliance DP4400:

Table of Contents

Remove and replace assemblies

Remove hard drive carrier from the mid hard drive tray

Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide

Figure 12 Removing the system cover

Before you begin

CAUTION

When a replacement hot swappable hard drive is installed and the system is

powered on, the hard drive automatically begins to rebuild. Ensure that the

replacement hard drive is blank or contains data that you wish to overwrite. Any

data on the replacement hard drive is immediately lost after the hard drive is

installed.

CAUTION

Mixing hard drive carriers from previous generations of PowerEdge servers is not

supported.

Procedure

1. Lift the hard drive carrier handle upward.

2. Press the release tab on the hard drive tray and lift the hard drive carrier handle

upward to disengage the hard drive from the backplane.

3. Hold the hard drive carrier handle and lift the hard drive carrier out of the hard

drive tray.

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the EMC Integrated Data Protection Appliance DP4400 and is the answer not in the manual?