Vflash Media (Optional); Installing A Vflash Media; Removing A Vflash Media; System Fan - Dell PowerEdge T410 Hardware Owner's Manual

VFlash Media (Optional)

The VFlash media is a Secure Digital (SD) card that can be used with the
optional iDRAC6 Enterprise card.

Installing a VFlash Media

1 Locate the VFlash media slot at the back of the system. See "Back-Panel
Features and Indicators" on page 20 for the location of the media slot.
2 With the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE:
3 Press the card to lock it into the slot.

Removing a VFlash Media

To remove the VFlash media, push inward on the card to release it and pull
the card from the card slot.

System Fan

Removing the System Fan

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING:
has been powered down. Allow time for the fan to stop spinning before removing it
from the system.
WARNING:
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 92.
The slot is keyed to ensure correct insertion of the card.
Only trained service technicians are authorized to remove the system
The system fan can continue to spin for some time after the system
Do not attempt to operate the system without the system fan.
Installing System Components
133