Dell PowerEdge T410 Hardware Owner's Manual page 130

6 Install the iDRAC6 Enterprise card:
Angle the card so that the RJ-45 connector fits through the
a
back-panel opening.
Align the front edge of the card with the two front plastic retention
b
standoffs near the iDRAC6 Enterprise card connector on the system
board. See Figure 6-1 for the location of the connector.
Press the card down until it is fully seated. See Figure 3-20.
c
When the front of the card is fully seated, the plastic standoff tabs
snap over the edge of the card.
7 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 93.
8 Close the system. See "Closing the System" on page 91.
9 Place the system upright and on its feet on a flat, stable surface.
10 Rotate the system feet outward.
11 Reattach any peripherals and connect the system to an electrical outlet.
12 Turn on the system and attached peripherals.
130
Installing System Components