Sd Vflash Card (Optional); Replacing An Optional Sd Vflash Media Card - Dell PowerEdge E31S Series Owner's Manual

Steps
1. Align the optical drive with the optical drive slot on the front of the chassis.
2. Slide in the optical drive until the release tab snaps into place.
3. Connect the power and data cable to the optical drive and system board.
NOTE: Route the cable properly on the side of the system to prevent it from being pinched or crimped.
Figure 112. Installing the optional optical drive
a. optical drive
b. power and data cable
c. release tab
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 66
Related tasks
Before working inside your system
After working inside your system

SD vFlash card (optional)

An SD vFlash card is a Secure Digital (SD) card that plugs into the SD vFlash card slot in the iDRAC port card. It provides
persistent on-demand local storage and a custom deployment environment that enables automation of server configuration,
scripts, and imaging. It emulates USB device(s). For more information, see the Integrated Dell Remote Access Controller User's
Guide at Dell.com/idracmanuals.

Replacing an optional SD vFlash media card

Steps
1. Locate the SD vFlash media slot on the system.
For PowerEdge R730 systems the SD vFlash media card is located on the front panel of the system.
2. To remove the SD vFlash media card, push the card inward to release it, and pull the card from the card slot.
172 Installing and removing system components
on page 67
on page 67