Troubleshooting Your System; Safety First - For You And Your System; Troubleshooting System Startup Failure; Troubleshooting External Connections - Dell PowerEdge T410 Hardware Owner's Manual

Troubleshooting Your System

Safety First — For You and Your System
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.

Troubleshooting System Startup Failure

If your system halts during startup prior to video imaging or LCD messaging,
especially after installing an operating system or reconfiguring your system's
hardware, check for the following conditions:
• If you boot the system to the BIOS boot mode after installing an operating
system from the UEFI Boot Manager, the system will hang. The reverse is
also true. You must boot to the same boot mode in which you installed the
operating system. See "Using the System Setup Program and UEFI Boot
Manager" on page 61.
• Invalid memory configurations could cause the system to halt at startup
without any video output. See "System Memory" on page 106.
For all other startup issues, note the LCD panel messages and any system
messages that appear onscreen. See "LCD Status Messages (Optional)" on
page 28 and "System Messages" on page 42 for more information.

Troubleshooting External Connections

Ensure that all external cables are securely attached to the external
connectors on your system before troubleshooting any external devices. See
Figure 1-1 and Figure 1-4 for the front- and back-panel connectors on your
system.
Troubleshooting Your System
155