Dell PowerEdge T410 Hardware Owner's Manual page 36

Table 1-2. LCD Status Messages (continued)
Code Text
E2010 Memory not
detected.
Inspect DIMMs.
E2011 Memory
configuration
failure. Check
DIMMs.
E2012 Memory
configured but
unusable.
Check DIMMs.
E2013 BIOS unable to
shadow memory.
Check DIMMs.
E2014 CMOS RAM
failure. Power
cycle AC.
E2015 DMA Controller
failure. Power
cycle AC.
E2016 Interrupt
Controller
failure. Power
cycle AC.
36
About Your System
Causes
No memory was detected
in the system.
Memory detected, but is
not configurable. Error
detected during memory
configuration.
Memory configured, but is
unusable.
The system BIOS failed to
copy its flash image into
memory.
CMOS failure. CMOS
RAM not functioning
properly.
DMA controller failure.
Interrupt controller
failure.
Corrective Actions
Install or reseat memory
modules. See "Installing
Memory Modules" on
page 110 or
"Troubleshooting System
Memory" on page 162.
See "Troubleshooting
System Memory" on
page 162.
See "Troubleshooting
System Memory" on
page 162.
See "Troubleshooting
System Memory" on
page 162.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.