Chassis Intrusion Switch; Removing The Chassis Intrusion Switch - Dell PowerEdge T410 Hardware Owner's Manual

Chassis Intrusion Switch

Removing the Chassis Intrusion Switch

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 Disconnect the chassis intrusion switch cable from the connector on the
system board. See Figure 3-25
5 Slide the chassis intrusion switch out of the securing bracket notch.
Figure 3-25. Removing and Installing the Chassis Intrusion Switch
Only trained service technicians are authorized to remove the system
Installing System Components
1
2
3
141