Lcd Status Messages (Optional) - Dell PowerEdge T410 Hardware Owner's Manual

LCD Status Messages (Optional)

The LCD messages refer to events recorded in the System Event Log (SEL).
For information on the SEL and configuring system management settings,
see the systems management software documentation.
NOTE:
If your system fails to boot, press the System ID button for at least five
seconds until an error code appears on the LCD. Record the code, then see "Getting
Help" on page 185.
Table 1-2. LCD Status Messages
Code Text
N/A SYSTEM NAME
E1000 Failsafe
voltage error.
Contact
support.
E1114 Ambient Temp
exceeds
allowed range.
28
About Your System
Causes
A 62-character string that
can be defined by the user
in the System Setup
program.
The SYSTEM NAME
displays under the
following conditions:
• The system is powered
on.
• The power is off and
active errors are
displayed.
Check the system event
log for critical failure
events.
Ambient temperature has
a reached a point outside
of the allowed range.
Corrective Actions
This message is for
information only.
You can change the
system ID and name in
the System Setup
program. See "Entering
the System Setup
Program" on page 62.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
See "Troubleshooting
System Cooling
Problems" on page 161.