Dell PowerEdge T410 Hardware Owner's Manual page 49

Table 1-3. System Messages (continued)
Message
Memory set to
minimum
frequency.
Memory tests
terminated by
keystroke.
MEMTEST lane
failure detected
on x
Mirror mode
disabled. For
mirror mode,
DIMMs must be
installed in
pairs. Pairs must
be matched in
size and
geometry.
Causes
The memory frequency may
be intentionally set lower for
power conservation.
The current memory
configuration may support
only the minimum
frequency.
POST memory test was
terminated by pressing the
spacebar.
Invalid memory
configuration. Mismatched
memory modules are
installed.
The memory configuration
does not match the setting in
BIOS. The BIOS setting has
been disabled.
Corrective Actions
If not an intentional setting,
check any other system
messages for possible causes.
Ensure that your memory
configuration supports the
higher frequency. See
"General Memory Module
Installation Guidelines" on
page 106.
Information only.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 106.
Reconfigure the memory
modules for Memory
Mirroring mode. See
"System Memory" on
page 106.
About Your System
49