Vflash Media (Optional) - Dell PowerEdge R415 Owner's Manual

Installing an iDRAC6 Enterprise Card
CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
3 Remove the system board shroud. See "Removing the System Board
Shroud" on page 109.
4 Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel.
5 Angle the card so that the RJ-45 connector fits through the back-panel
opening. See Figure 3-19.
6 Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 connector on the system board, and lower
the card into place. See Figure 3-19.
When the front of the card is fully seated, the plastic standoffs snap over
the edge of the card.
7 Close the system. See "Closing the System" on page 83.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.

VFlash Media (Optional)

The VFlash media card is a Secure Digital (SD) card that plugs into the
optional iDRAC6 Enterprise card at the back corner of the system.
Removing a VFlash Media Card
To remove the VFlash media, push inward on the card to release it, and pull
the card from the card slot.
116
Installing System Components
Many repairs may only be done by a certified service technician.