Installing A Non-Redundant Power Supply; Internal Usb Memory Key - Dell PowerEdge T410 Hardware Owner's Manual

Installing a Non-Redundant Power Supply

1 Slide the power supply into the back of the chassis.
2 Replace the screws that secure the power supply to the chassis.
See Figure 3-17.
3 Connect all the power cables to the system board and drives.
Ensure that all the cables are routed properly to prevent the cables from
being pinched or crimped.
4 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 93.
5 Close the system. See "Closing the System" on page 91.
6 Place the system upright and on its feet on a flat, stable surface.
7 Rotate the system feet outward.
8 Reattach any peripherals and connect the system to an electrical outlet.
9 Turn on the system and attached peripherals.

Internal USB Memory Key

An optional USB memory key installed inside your system can be used as a
boot device, security key, or mass storage device.
WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 Locate the USB connector on the system board. See Figure 6-1.
5 Insert the USB memory key into the USB connector. See Figure 3-18.
6 Close the system. See "Closing the System" on page 91.
7 Place the system upright and on its feet on a flat, stable surface.
8 Rotate the system feet outward.
9 Reattach any peripherals and connect the system to an electrical outlet.
Only trained service technicians are authorized to remove the system
Installing System Components
125