Dell PowerEdge T410 Hardware Owner's Manual page 29

Table 1-2. LCD Status Messages (continued)
Code Text
E1116 Memory
disabled, temp
above range.
Power cycle
AC.
E1210 Motherboard
battery
failure. Check
battery.
E1211 RAID
Controller
battery
failure. Check
battery.
E1216 3.3V Regulator
failure.
Reseat PCIe
cards.
E1229 CPU # VCORE
Regulator
failure.
Reseat CPU.
Causes
Memory has exceeded
allowable temperature and
has been disabled to
prevent damage to the
components.
CMOS battery is missing
or the voltage is outside of
the allowable range.
RAID battery is either
missing, bad, or unable to
recharge due to thermal
issues.
3.3V voltage regulator has
failed.
Specified processor
VCORE voltage regulator
has failed.
Corrective Actions
Remove AC power to the
system for 10 seconds and
restart the system.
See "Troubleshooting
System Cooling
Problems" on page 161. If
the problem persists, see
"Getting Help" on
page 185.
See "Troubleshooting the
System Battery" on
page 160.
Reseat the RAID battery
connector. See "Installing
a RAID Battery" on
page 120, and
"Troubleshooting System
Cooling Problems" on
page 161.
Remove and reseat the
PCIe expansion cards. If
the problem persists, see
"Troubleshooting
Expansion Cards" on
page 169.
Reseat the processor(s).
See "Troubleshooting the
Processors" on page 171.
If the problem persists,
see "Getting Help" on
page 185.
About Your System
29