Dell PowerEdge T410 Hardware Owner's Manual page 40

Table 1-2. LCD Status Messages (continued)
Code Text
E2113 Mem mirror OFF
on DIMM ## &
##. Power
cycle AC
I1910 Intrusion
detected.
Check chassis
cover.
I1911 LCD Log Full.
Check SEL to
review all
Errors.
I1912 SEL full.
Review & clear
log.
I1920 iDRAC6 Upgrade
Successful
W1228 RAID
Controller
battery
capacity <
24hr.
40
About Your System
Causes
The system BIOS has
disabled memory
mirroring because it has
determined one half of the
mirror has had too many
errors. "## & ##"
represents the memory-
module pair implicated by
the BIOS.
System cover has been
removed.
LCD overflow message. A
maximum of ten error
messages can display
sequentially on the LCD.
The eleventh message
instructs the user to check
the SEL for details on the
events.
The SEL is full of events
and is unable to log any
more.
iDRAC6 Express card has
been installed correctly
Warns predictively that
the RAID battery has less
than 24 hours of charge
left.
Corrective Actions
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Troubleshooting
System Memory" on
page 162.
Information only.
Check the SEL for details
on the events.
Remove AC power to the
system for 10 seconds or
clear the SEL.
Check the SEL for details
on the events, then clear
the SEL.
Information only
Allow RAID battery to
charge to greater than 24
hours of sustained charge.
If problem persists,
replace RAID battery. See
"Installing a RAID
Battery."