Dell PowerEdge T410 Hardware Owner's Manual page 111

3 Open the system. See "Opening the System" on page 90.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 92.
5 Locate the memory module sockets. See Figure 6-1.
6 Remove the memory-module blanks from the sockets in which you plan to
install memory modules:
Press out the ejectors on each end of the socket until the memory-module
blank pops out of the socket. See Figure 3-13.
NOTE:
use.
7 Handle each memory module only on either card edge, ensuring not to
touch the middle of the memory module.
Figure 3-13. Installing and Removing a Memory Module
1 memory module
3 alignment key
Make sure to retain any removed memory-module blanks for future
2 memory module socket ejectors (2)
Installing System Components
1
2
3
111