Installing Memory Modules - Dell PowerEdge T410 Hardware Owner's Manual

Table 3-2. Sample UDIMM Memory Configurations (Per Processor)
Memory
Memory Module
Mode Size
Optimizer 1-GB
2-GB
Advanced 1-GB
1
ECC
2-GB
Mirroring 1-GB
2-GB
1. Requires x4- or x8-based memory modules.

Installing Memory Modules

WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING:
system has been powered down. Allow time for the memory modules to cool
before handling them. Handle the memory modules by the card edges and avoid
touching the components on the memory module.
CAUTION:
installed in any memory socket that is not occupied. Remove memory-module
blanks only if you intend to install memory in those sockets.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 Rotate the system feet inward and lay the system on a flat surface.
110
Installing System Components
Memory
Sockets
4 1 2
X
X X
X X
X X X
X
X X
X X
X X X
X X
X X
X X
X X
Only trained service technicians are authorized to remove the system
The memory modules are hot to the touch for some time after the
To ensure proper system cooling, memory-module blanks must be
Single Processor
3 Physical Available
Memory Memory
(GB) (GB)
1
2
X 3
X
4
2
4
X
6
X
8
2
4
2
4
Dual Processor
Physical
Memory
(GB)
all 2
4
6
8
all 4
8
12
16
all 4
all 8
1 4
2 8
Available
Memory
(GB)
all
all
all
all
2
4