Table of Contents
Advertisement
T
Wake Up from Suspend Alarm/Resume Alarm Time — Lets you set a resume
time from Suspend mode.
Peripherals Setup
The Peripherals Setup menu displays the connection locations between the system and the
Input/Output (I/O) ports. This menu also lets you specify different port assignments as
needed.
T
Serial Port — Allows you to disable the port or change its address assignment.
T
Parallel Port/Parallel Mode — Lets you disable or reassign the parallel port and
select a parallel port mode.
T
IR Serial Port/IR Serial Mode— Allows you to disable or reassign the IR serial
port and select an IR mode.
T
TV Out Port — Specifies the signal type (NTSC or PAL) used by the TV being
connected to the TV Out port.
T
Sound/Sound IRQ/Sound SB-Compatible DMA/Full-Duplex Mode DMA — Se-
lects the sound parameter to user defined, disabled or reconfigure. Change addi-
tional sound related items as needed.
Other Setup Options
Setup offers other options, including the following:
T
Change User Password — Lets you set a user password once a Supervisor pass-
word is set.
T
Change Supervisor Password — Sets a Supervisor password at system startup.
T
Auto Configuration with Defaults — Loads default settings.
T
Save Settings and Exit — Accepts changes made to current settings, saves to
CMOS, and exits Setup.
T
Exit Without Saving — Reverts to previously selected settings and exits Setup.
NOTE
If you disable a device in Setup, you cannot
enable or assign it using the Windows 95 device
manager. The device is not listed in the Windows
95 device list. To control the device using the
Windows 95 device manager, select any setting
other than "Disable" in Setup.
Setup and Operation
2-33
Advertisement
Chapters
Table of Contents
